Magnum XLF-20C *DISCONTINUED


Common Mode Filtercord for CB and Mobile Electronics, Input 6 - 16 VDC, Up to 20A, Connector Uniden/President T-3.
Packing Blister-1.


More Information
Price End user EU €9.999,00 incl. VAT/BTW/TVA
Price End user Non EU €8.263,64 excl. VAT/BTW/TVA
Stock Out of stock
Avera p/n MAGN XLF20C
Brand Magnum
Type Magnum XLF-20C *DISCONTINUED
Category DIAMOND Products
Sub Category Discontinued
Packing Length (cm) 22
Packing Width (cm) 12
Packing Heigth (cm) 5
Packing Weight in grams 340
Packing Type Blister-1
Packing QTY in Master Carton 10
Statistical Number 85256000
Origin China
More information Servicedocs.com

The XLF-20C™ XLF-20M™ look exactly like the original PLF-10C™ PLF-10M™, the differences are in the electrical circuits.

All noise or interference enters a 2-way radio thru the antenna system or the 12 volt DC lines.

The XLF-20C™ XLF-20M™ are rated at: 6-16 Volts DC 20 amps continuously, and are known as COMMONMODE filters. Unlike the PLF the XLFs address a WIDER range of interference problems and will reduce or eliminate not only DC noisewhich include alternator, turn signals and windshield wipers, it will also cancel any RFI that is coupled into the DC line, and due to its design there is absolutly no voltage drop thru the filter. In addition the commonmode filter provides the highest isolation to both RF and Noise.

Commonmode filters will reduce or eliminate noises in all 12 volt electronic components, these include 2 way radios, audio systems, including AM/FM receivers, stereos, amplifiers and video components.
The instructions on the backer card now give instructions for a simple test that will determine if the noise/interference is thru the Antenna or DC lines.

CAUTION:
The XLF-20 is rated at 20 amps continuous and 25 amps peak.
If the device exceeds 25 amps peak current drain, do not use the filter.

PRE-INSTALLATION TEST:
All noise or interference comes into your radio either through the antenna system or the DC power Lines.
The XLF-20 will effectively cancel or reduce the noise coming through the DC power Lines.
To determine if the noise you are experiencing is coming in through the antenna system or DC power line conduct this simple test:

1. Start the vehicle and listen carefully to your radio’s receiver noting all interference and noises.
Start and stop the various DC switches and motors in the vehicle (windshield wipers, turn signals, etc.).

2. Unscrew the antenna from the back of the radio and replace it with a dummy load.

3. Repeat step 1 and compare noise and interference levels.

4. Any noise or interference that remains after the antenna system has been replaced with a dummy load will be reduced or eliminated by using the XLF-20.



LINK(S) TO VIDEO OF THIS PRODUCT:
Links to video’s to be published as soon as possible.
Feel free to send link suggestions.

ADDITIONAL SEARCH OPTIONS:
MagnumXLF20C, XLF20C, XLF20, XLF-20, XLF-20C

BARCODE:
Not available on the product

This product was added to our website (or changed) on Tuesday 10 July 2012.

For quantity pricing please contact our sales desk.

Although the information and specifications at this internet site are presented in good faith and believed to be correct, Avera B.V. makes no representations or warranties as to the completeness or accuracy of the information.

BELOW IN RED IS A LINK TO SERVICEDOCS.COM
Click the link for more detailed information on this product.


Copyright © 2019 Avera Distributing. All rights reserved.