Wilson 1000-MAG ANTENNA
Antenna CB Mobile, Magnetic Mount, Version Black, Whip Stainless Steel, Length 175cm, 1000W/3000W.
(Photo shows Black and White Version, White Version is discontinued)
|Price End user EU||€ 144,00 incl. VAT/BTW/TVA|
|Price End user Non EU||€ 119,01 excl. VAT/BTW/TVA|
|Type||Wilson 1000-MAG ANTENNA|
|Sub Category||Antennas: CB Mobile MagMount|
|Packing Length (cm)||13|
|Packing Width (cm)||13|
|Packing Heigth (cm)||160|
|Packing Weight in grams||1405|
|Packing QTY in Master Carton||12|
Features, Functions and Specifications:
• Gain performance proven by power gain tests at Lockheed Corporation Antenna Test Laboratory
• 3000 Watt power handling capability (ICAS)
• Made with high impact Mobay Thermoplastic
• 10 gauge silver-plated coil winding
• Exclusive low loss coil design (Patent #4,882,591)
• 62 17-7 PH Tapered spring stainless steel whip
• Frequency range 26 MHz to 30 MHz
• Weather Channel Ready
• Available in Roof Top, Trunk Lip, or Magnetic Mounts
• Removable coil for safe storage garage entrance
• Weather Cap included to protect mount when coil is removed
• Color choices: Black or White
• 2 year Warranty
WHY THE Wilson 1000 PERFORMS BETTER:
The Wilson 1000’s higher gain performance is a result of several new design developments that bring to you the most powerful CB base loaded antenna available in its price range
A large portion of the power that goes into a typical base loaded CB antenna is lost as heat in the coil and as dielectric heat loss in the plastic inside the coil form. Many CB antennas lose more than 50% of the power put into them. The power is wasted as heat loss and not radiated as radio waves. Another weak link in other CB antennas is the capacitor used to match the coax to the antenna, which is a cheap and easy way to make the SWR look good, but has lots of power loss, plus blows out when high power is applied to it.
The first priority was to reduce the dielectric loss by removing as much of the plastic inside the coil as possible. This was accomplished by suspending the coil in air, supported only at four small points, 90 degrees apart, in effect removing 95% of the plastic from the inside surface of the coil. This reduced the dielectric loss to a negligible amount.
The second priority was to get rid of the resistive heat losses in the coil. Since most of the RF energy at 27 MHz travels on the surface of the wire, it was decided to increase the surface area by making the diameter of the wire larger 10 GA copper. Since silver is a much better conductor than copper, although very expensive, the wire was heavily silver plated. This reduced the resistive loss to a minimum.
Finally, to get rid of the losses in the matching between the coax and the loading coil, the lossy capacitor was eliminated and a difficult but more efficient means of coupling the antenna was used. A Scalar Network Analyzer was used to determine the very precise point to direct match the coil with the coax and obtain the best match with maximum power transfer, which gives the 3000 watts of power handling capability.
So far you have read about why the Wilson 1000 performs better, but the Wilson 1000 is also the most rugged antenna you can buy. It is made with Mobay’s Thermoplastic which costs a lot more, but it’s the best available.
*TEST RESULTS: In tests conducted by Lockheed Corporation, one of the worlds largest Aerospace Companies, at their Rye Canyon Laboratory and Antenna Test Range, the Wilson 1000 was found to have 58% more power gain than the K-40 Electronics Company, K40 CB Antenna. This means that the Wilson 1000 gives you 58% more gain on both transmit and receive, on channel 40. Now you can instantly increase your operating range by installing a Wilson 1000.
ANTENNA POWER GAIN : The amount of improvement in power amplification over another antenna. The higher gain antenna will transmit receive farther, but the actual distance will vary depending on the gain, ground terrain and other environmental factors. Individual test results may vary due to the vehicles ground plane and matching configuration.
1 Pc of Wilson 1000 MagM BL
AVAILABLE SPARE PARTS:
* 880-900100B = W1000 Replacement Coil
* 880-90813B = Spare MagMount for W1000.
* 880-900901 = Original ReplacementWhip 159 cm.
* 880-900906 = Longer Replacement Whip 168 cm.
* 880-900501 = Replacement Set Scew, 32 x 18.
* 880-901000 = W1000 Hardware Bag.
* 880-910010 = W1000/W5000 Mag mount Repair Kit.
LINK(S) TO VIDEO OF THIS PRODUCT:
Links to video’s to be published as soon as possible.
Feel free to send link suggestions.
ADDITIONAL SEARCH OPTIONS:
Wilson 1000 MagM BL,880-900800B.
This product was added to our website (or changed) on Wednesday 10 October 2012.
For quantity pricing please contact our sales desk.
Although the information and specifications at this internet site are presented in good faith and believed to be correct, Avera B.V. makes no representations or warranties as to the completeness or accuracy of the information.
BELOW IN RED IS A LINK TO SERVICEDOCS.COM
Click the link for more detailed information on this product.